All kinds of sliding bearings of VIIPLUS CHINA brand are widely used in chassis system, body system and hydraulic system of construction machinery and construction machinery.Bimetal Bushings friction welded shaft sleeve is applied to supporting heavy wheel, supporting sprocket wheel and guiding wheel.Bimetal and LIKE DU, DX series bushing are used in the arm frame, connecting rod, supporting leg, etc.CAST BRONZE PULG GRAPHITE BUSHING C86300 BRONZE BEARINGS series Mosaic solid lubrication sleeve used in movable arm, arm, modulating mechanism, cylinder etc. Bimetallic Material Or Bronze Lead Steel Bearing Bushings Strip CuPb10Sn10 JF800 Plain bearing materials Plain bearing Strips, Plain Bearing Strips | Bimetal Strips CuPb10Sn10 JF800 Bimetallic material or Bronze lead steel strip Custom composite CuPb10Sn10 bimetal bush The strongest type, wide application field, most suitable for high impact vibrating load bushes and Washers.
For all the global industryProvide high-quality self-lubricating
Wrapped Steel Self Lubricating Bearings Oilless Sliding Series
JF series materials, also known as bimetallic materials or copper lead steel strips, are made of low carbon steel or steel coil as the base material, and the surface is sintered with copper alloy steel and copper alloy products. Different copper alloy materials are suitable for different working conditions. The surface copper alloy grades can be divided into high lead series, lead series and lead-free series.
Main chemical composition%
Alloy hardness HB
Steel layer hardness HB
Main use occasion
Bushing, side plate, washer
1,The CuPb10Sn10 materials in the above table are tested by the Wuhan Institute of Materials Protection, Ministry of Machinery Industry. The measured fatigue strength of the Glacier.vandere11 sapphire bearing fatigue tester in the UK is greater than 125Mpa. 2,“—”is not detected.
Bimetal bushing Application Bimetal Bushings are widely used in various parts of automobile industries such as engines, transmission cases, vehicle chassis, steering knuckle, trunnion shaft, leaf spring, motorcycle clutches, wear plating of gear pumps,as well ashoisting machines, etc.
It is backed with high quality low carbon steel with bronze alloy sintered on its surface. To effectively decrease abrasion, its alloy surface can be machined with ball shaped oil pockets for easier oil storage. When necessary, an anti-corrosion coating can be plated on the steel back. It can be applied to conditions of mediate load with mediate or high running velocity and conditions with enormous impact load. Such as internal combustion engine bearing,connecting rod bearing, rock arm bearing, slide plate of oil gear pump and etc